| ORIGINAL | STAGE 1 | DIFFERENCE | |
|---|---|---|---|
| Power (hp) | |||
| Torque (Nm) | |||
25 October 2024 / BalticTuning
Audi A6 MD1CP004 Adblue off (SCR) with cruise control working
From time to time we got requests for adblue system off for MD1CP004 ECU. Use of automated programs results in switched off cruise control.We know software switches, that cant be touched to correctly switch off SCR system.ECU: BOSCH MD1_CP004SW: 4G2907311B 0002 10SW002127Car: Audi A6 C7 3.0TDI Engine code: CZVA
View More
27 September 2024 / BalticTuning
John Deere 6215R Phoenix L33 Stage1, SCR, DPF, EGR
Daly working with tractors, we have good working solution for John Deere Phoenix ECUsIn this example Phoenix L33.Here we had fault for DPF ECU 4795.31 ECU 004795.31 - DPF MissingFor this tractor we did tuning file for more torque and power to be more efficient plus all ecology off - DPF off, SCR off, EGR off.For this kind of engine we suggest EGR stay working - to reduce combustion temps.For Phoen...
View More
19 September 2024 / BalticTuning
KUBOTA KX080 Excavator 46.5kW year 2019 with DENSO ECU, DPF EGR off
We have working DPF EGR off solution for Kubota Excavator 2019 equipped with DENSO ECU.When having problems with DPF in our case fault on display 076 (also possible 078) - it is related to DPF. When starting engine it works in limp mode and after some time stalls.When reading ecu faults with diagnostic tool: fault codes present in ECU: P3006 P3007 P2455. ECU: DENSO 1J773-59052 ...
View More
18 September 2024 / BalticTuning
MAN TGX 18.440 Stage1 tuning file
Tuning for MAN TGX 18.440 440hp version. With our tuning file we get as Stage1 500hp and +15% increase in torque.To read and write this ECU we used Dimsport Trasdata bench connection. After optimising software also fuel consumption is less because of more efficiency. ECU: BOSCH EDC17CV42 0281020273 HW/SW: 51.25804-3773 / 1037541468 / 508917
View More
17 September 2024 / BalticTuning
Tuning file BMW X7 3.0d stock 265hp MD1CP002 Stage1
Tuning file for BMW X7 3.0d 265hp MD1CP002 Stage1Optimized drivers wish map, better throttle responseOptimised torque model for good torque and power. Sports displays calibration etc.ECU: MD1CP002SW: B57D30O0-G07B57O0_AWR1_AT#S18A-22-11-500-ATS (O_8KXW0-00005D63-017)O_8KXW0-00005D63-017Stage1: 326hp 723Nm
View More
17 September 2024 / BalticTuning
BMW M5 F90 4.4 V8 Eventuri intake and Custom exhaust with downpipes.
Tuning file news, we have worked on BMW M5 F90 with some mods - Eventuri intake and custom exhaust (no CATs).With our custom tune (intake and downpipe) we achieved 780hp and 980Nm For this car when changing intercoolers for bigger ones it is important to fill up water up to level, otherwise You fill get limp home mode. Also it is quiet tricky to bleed air from that system. This car is equipped wit...
View More
17 September 2024 / BalticTuning
Audi A6 C4 2.5TDi chiptuning MSA11
Long time ago this is how chip tuning started...We are able to make tuning for this Audi C4 2.5TDi Eng. code: AEL with erasable EPROMS.There are 2 EEPROMS each with different maps.In one eerpom there are torque limit map, drivers wish, injection pump voltage map. In second eeprom boost maps, incl. one byte max boost, injection timing, etc.With good software optimization it is possible to get aprox...
View More
12 September 2024 / BalticTuning
Toyota Yaris 1.0 VVT-i Stage1+ tuning.
Tuning news, we have developed good tuning file for Toyota Yaris 1.0 VVT-i this is more for racing use. We have opimised ignition for full and part load, but most important - fueling. In lower rpm regions this engine is running with quiet lean mixture for full load - that is till aprox. 4000 rpm's and quiet rich 0.78 ath higher rpms. We found maps that are responsible for full throttle lambda and...
View More
22 May 2024 / BalticTuning
Mitsubishi L200 Adblue off (SCR off), with DPF still in place and regeneration ok. Fault code U010E
Mitsubishi L200 Adblue offECU: DENSO SW: H1EC4P45HPZ1HPZ13502 H1EC4P45HPZ1HPZ13201For this ECU if You want to disable only Adblue - SCR system with working DPF regeneration You need correct SCR off solution and also disconnect DCU. With several tests we made working solution for this ECU type.If You have incorrectly switched off Adblue, DPF stops regenerating and after some km it gets clog...
View More
22 May 2024 / BalticTuning
BMW M5 5.0 V8 e39 400hp with Supersprint exhaust wo CAT - FAULT B2 B3. Dyno mode RPM fix 5700 to 6800 1/min
BMW M5 5.0 V8 400hp e39 ECU: Siemens MSS52SW: 7837965 HW18 61104DB2 1601Read write: Alientech Kess3 OBDWe worked on BMW M5 e39 ECU software to disable faults regarding CAT. B2 - “Catalyst system efficiency, Cyl #1-4”B3 - “Catalyst system efficiency, Cyl #5-8”Disabled rpm's when CAT diagnostics are enabled.Also, we fixed Dyno rev. limit from 5700 to 6800, no more fuse removingWe also can de...
View More